Over and under ?

Discussion in 'Shooting - Reloading Forum' started by Wareaglebrowning, Jan 28, 2018.

  1. Ravenanme

    Ravenanme Elite Refuge Member

    Messages:
    2,434
    Joined:
    Sep 26, 2014
    Location:
    Close to where I hunt
    I do agree with , if the lever isn't to the right of center and you can make a LOW price deal for it , it really doesn't cost that much to have a NEW Cam
    installed bringing it back to ALMOST new again ! Brownings would be a better choice for this along with Beretta's who have 3" chambers mostly .
     
  2. Tuleman

    Tuleman Elite Refuge Member

    Messages:
    6,104
    Joined:
    Feb 5, 2005
    Location:
    Central Kansas
    Not a cam that is worn, either the locking lugs or the locking notches/holes, or both, are worn. Replacing the lugs is not all that costly, but repairing the locking holes/notches can cost several hundred dollars.
     
  3. oldman1949

    oldman1949 Elite Refuge Member

    Messages:
    3,985
    Joined:
    Feb 15, 2002
    Location:
    Northwest Indiana
    Phillips Gunsmithing :
    "$125.00 - Weld-up locking Block and Fit"

    Every time I see a 680 series Beretta with the lever left of center for sale cheap because it is "wore out" I buy it .
     
  4. OneShotBandit

    OneShotBandit Elite Refuge Member

    Messages:
    8,625
    Joined:
    Feb 27, 2001
    Location:
    Indiana
    I had my 682 Super Sporting done by Coles ~$250, but boy is she tight! ;) :yes
     

Share This Page