Trolling motors

Discussion in 'Boats, Blinds, & Gadgets Forum' started by gadwall52, Apr 27, 2018.

  1. gadwall52

    gadwall52 Elite Refuge Member

    Messages:
    2,100
    Joined:
    Nov 28, 2007
    Location:
    dodge city kansas
    Ok, In my internet searches I discovered that this is a run /charge setup. There was a red plug that would be connected to a charger so that one could just plug in the charger when at home. I think I'm just going to pull the second set of lines and hard wire the TM for now. I have a norinco three prong plug that a customer ordered but didn't pick up, but no receptacle. I'll have to wait till the COD says there is sufficient funds to order one
     
  2. gadwall52

    gadwall52 Elite Refuge Member

    Messages:
    2,100
    Joined:
    Nov 28, 2007
    Location:
    dodge city kansas
    Finally got the thing running again, I think. Would run out of the,water but not in it. Pulled the prop off and the shear pin was off center and weeds wrapped around the shaft. Removed those and put the prop back on and it runs.
     

Share This Page