10 gauge wads?

[Gabriel golden eyes]

I've not used them. Joe Speroni, the late great author of "High Performance Reloading for the 10 Gauge shotgun" writes in his book, "Cheddite also offers 10 gauge hulls, however after thorough testing, I did not find them of adequate quality to invest in them and there is little to no load data available." He knows more, and did more load testing than anybody I've ever heard of. You could try a few, but for my money, I would use Remington's or Federal's, or Winchester hulls. If you can find them. Good luck!

I use the same load data as federal hulls and the primers don't get loose like the federals after a couple reloads, I have probably two hundred hulls that have been reloaded over ten times

 

[C M Wings]

I use the same load data as federal hulls and the primers don't get loose like the federals after a couple reloads, I have probably two hundred hulls that have been reloaded over ten times

Yeah this is my experience too. They load fine, but the super metallic crimp starter is a must. They actually have a tad more volume than federal hulls. I load 42-43gnd s of steel powder in them and TPS wad Guys on here go to 46 with RSI.