Rate my DIY roll crimp

[PaulinKansas]

Built it with the materials in the picture.

 

[Dr Swane]

Built it with the materials in the picture.

View attachment 382130

Easily loads into your .410 gun?

 

[PaulinKansas]

Easily loads into your .410 gun?

I don't know. Don't have any overshot cards or any powder like 'Lil Gun or H110. That was my first attempt at a roll crimp.

 

[Jim Atlas]

If it loads, then awesome.

 

[PaulinKansas]

If it loads, then awesome.

I'm using a pump. Once fired shells go in the chamber but they don't come out. New primed Fiocchi hulls are being delivered today.

 

[JP]

A collett resizer would likely remedy your once fired hull extraction issue. Unless, the load is a bit hot and causing over pressure indications.

 

[JRS]

I voted “dog poop” because it’ll be the only time I ever get to vote “dog poop”

Looks like it’ll work, put some guts in a hull and try it

 

[PaulinKansas]

A collett resizer would likely remedy your once fired hull extraction issue. Unless, the load is a bit hot and causing over pressure indications.

It was a once fired roll crimped hull with no powder/primer/powder/wad that didn't extract. I got some H110 today and my unfired primed hulls arrived too. Loaded one up, fired it, and it extracted with no problem.

 

[A5B]

I voted dog poop only because it's not every day I get to vote dog poop.

Heck looks good to me but I know nothing about roll crimps. I do all my loads with a 6 point fold, trying to avoid roll crimps at all cost.

 

[JP]

It was a once fired roll crimped hull with no powder/primer/powder/wad that didn't extract. I got some H110 today and my unfired primed hulls arrived too. Loaded one up, fired it, and it extracted with no problem.

If once fired hulls aren’t resized, they can be problematic.