Xtrema2 Ejector Pin

Discussion in 'Shooting - Reloading Forum' started by Jeff32, Sep 12, 2019.

  1. Jeff32

    Jeff32 New Member

    Messages:
    2
    Joined:
    Sep 11, 2019
    Could someone please help me out with the proper procedure to remove an ejector pin in an Xtrema2 12 gauge? I had called Beretta but of course they cannot give any Gunsmithing advice. Just want to make sure this is done properly so the bolt is not damaged. Thank you in advance. - Jeff
     
  2. CA Birdman

    CA Birdman Elite Refuge Member

    Messages:
    10,375
    Joined:
    Dec 31, 2001
    Location:
    Elk Grove, CA
    do google search and good article on how to do it on shotgun world. I have done extractor but not the ejector on the bolt.
     
  3. Jeff32

    Jeff32 New Member

    Messages:
    2
    Joined:
    Sep 11, 2019
    Thanks for the reply. I meant to say extractor, oops, my bad. Anyway, any help will be appreciated. Thanks.
     
  4. CA Birdman

    CA Birdman Elite Refuge Member

    Messages:
    10,375
    Joined:
    Dec 31, 2001
    Location:
    Elk Grove, CA
    There are couple posts on shotgun world. If you can't find something, I'll pull mine and try and remember how I did it. It took all of 2 minutes.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice